Description
Audi SQ2 2.0 Stage 1 Remap
The latest generation 2.0TSI engine has seen some substantial changes in factory form to keep in line with the latest emissions laws. Most notable is the introduction of the GPF (Gasoline Particulate Filter) and the change to the single port injection system. Close monitoring of the GPF system has been an essential step in finding the limitations and tuning potential of the newer DNU* engines. The general consensus is that the GPF not only mutes but limits the engine power, Revo ECU calibration might be a reason to dispute that.
Enhancing the vehicle with Revo ECU Software gives you much more than just an increase in power and torque. A large part of development is based on drive cycle and driver feedback, our calibration doesn’t just give a great dyno curve and peak power/torque figures but also delivers in feel; giving a smoother yet more responsive feel at low RPM/ partial throttle with huge gains at wide-open throttle throughout the whole rev range.
Only Revo performance ECU Software maintains factory safety levels and additional driving features. You can switch between three pre-set fuel quality modes depending on the fuel you use; these modes are set through testing our development vehicles in varying climatic conditions with a range of fuel quality throughout the world. The Revo SPS Software Switch is also available separately, can be used to quickly switch between performance modes and access the additional Anti-Theft mode.
What’s included?
- Revo ECU Software (Optional TCU)
- Health Checks & Datalogging
- Air Intake Fitting (if required)
Reviews
There are no reviews yet.